Print, Transfer, Etch

Finally got to radioshack and got a starter bottle of ferric chloride, and a dual sided copper board, I also finished the final, ready to etch versions of the boards. All the extra vias on the motor control board are for a little prototyping area.

Both layers of the motor controller board, the extra vias in the bottom left side of the board is a small prototyping area.
Both layers of the motor controller board, the extra vias in the bottom left side of the board is a small prototyping area.

bobmotorbotbobmotortop

The main power board, the DIP, LEDs and Pots are a battery voltage monitor
The main power board, the DIP, LEDs and Pots are a battery voltage monitor

bobpowerbotbobpowertopbobmainallbobmainbotbobmaintop

One thought on “Print, Transfer, Etch

Comments are closed.